FEATURES: Construction: Laser cut balsa
          Wing: Two piece with center section, high mount placement
          Covering: Two sheets of red and two sheets of white tissue
          Cowl: Vacuum molded plastic, white in color
          Landing Gear: Preformed wire .062" (1.6mm) diameter with .032"
            (0.81mm) diameter tail wheel wire
          Wheels: Two 1.75" (45mm) diameter lightweight foam main wheels and
            one 0.75" (19mm) plastic tail wheel
          Windows: Three sheets acetate with pattern in manual for all windows
          Rudder: Pull-pull style with horn and cables included

INCLUDES: All required balsa, two sheets red and two sheets white tissue, cowl,
            two decal sheets, three wheels, three acetate sheets, hardware,
            instruction manual and two full-size plan sheets

REQUIRES: Electric Motor: GWS "A" or MPI EPU-6 drive unit
          Radio: 3-channel with micro size receiver
          Servos: Two micro size for rudder and elevator
          Electronic Speed Control: 5A with BEC
          Battery: 7.4V 700mAh Lithium Polymer
          Propeller: 9x7 for electric application
          Finish For Covering: Butyrate dope such as Midwest Aerogloss, light-
            weight Mylar covering can also be used, see COMMENTS
          Building and field equipment

SPECS:    Length: 27" (68.6cm)
          Wingspan: 40" (101.6cm)
          Wing Area: 215 sq in (13.89 sq dm)
          Motor Placement: Offset 1.5° right thrust
          Center of Gravity (CG): 1-7/8" (48mm) from the leading edge of the
            wing measured at the fuselage
          Control Throws:
            Elevator: up and down   3/4" (19mm)
            Rudder: left and right  7/8" (22mm)
            Airfoil: Flat bottom

COMMENTS: Do not use Ultra Cote or MonoKote covering. It is too heavy and will
            shrink too much damaging the lightweight structures.