FEATURES: Construction: Laser cut balsa
          Wing:         Two piece with center section, high mount placement
          Covering:     Two sheets of red and two sheets of white tissue
          Cowl:         Vacuum molded plastic, white in color
          Wheels:  Two 1.75" (45mm) diameter lightweight foam main wheels and
                     one 0.75" (19mm) plastic tail wheel
          Windows: Three sheets acetate with pattern in manual for all windows

INCLUDES: All required balsa, One sheet of yellow tissue, cowl, one fake
            engine decal, two wheels, one sheet, hardware, instruction
            manual and two full-size plan sheets.

REQUIRES: Electric Motor: GWS "A" or MPI EPU-6 drive unit
          Radio: 3-channel with micro size receiver
          Servos: Two micro size for rudder and elevator
          Electronic Speed Control: 5A with BEC
          Battery: 7.4V 700mAh Lithium Polymer
          Propeller: 9x7 for electric application
          Finish For Covering: Butyrate dope such as Midwest Aerogloss, light-
            weight Mylar covering can also be used, see COMMENTS
          Building and field equipment

SPECS:    Wingspan: 35" (889mm)
          Center of Gravity (CG): 2-7/16"(62mm) from the leading edge of the
            wing measured at the fuselage
          Control Throws:
            Elevator: up and down   3/4" (19mm)
            Rudder: left and right  5/8" (16mm)
            Airfoil: Flat bottom

COMMENTS: Do not use Ultra Cote or MonoKote covering. It is too heavy and will
            shrink too much damaging the lightweight structures